Everything you need included in a single package. The ultimate paramotor smoke system, designed from end to end for PPG applications. It’s not an RC airplane pump or a window washer fluid pump.
Our PPG smoke system is a ball bearing based, high flow rate, low energy consumption pump - specifically designed ppg smoke applications. Compatible with aircraft smoke oil or baby oil.
The injection nozzle itself is drillable up to 1.58mm for a full 300ml flow rate from the PPG Smoke pump system. We recommend doing this in .5mm increments until you get the desired smoke amount you want.
Lightweight, small form-factor and single piece pump design with a power switch and on/off smoke toggle. Lasts up to 4 hours on rechargeable AA batteries or 120 flights with 2 minute smoke runs. There are no LiPo batteries (fire hazard) or separate LiPo battery chargers required (extra cost).
Installation and setup takes 15 minutes.
- 1000 ml fluid container
- 300 ml per minute flow rate
- .08mm to 1.58mm adjustable flow rate injection nozzle
- 1.6 to 2 minutes of smoke per flight
- 4 hours or 120 flights of battery life
- 6v input
- Dry weight: 433g
- Wet weight: 1433g
- Dimensions: 25cm * 9cm * 9cm
- Smoke Pump
- Smoke Fluid Mount
- Smoke Hardware Kit
- Rivnut gun
- 4 AA batteries
- 7mm drill bit
- 450° high temp. threadlock